Where is the fuel pump reset switch location on the Chevy Silverado?

The 2003 Chevy Silverado fuel pump reset switch location is on the toe-board, to the right of the transmission hump, in the passenger-side footwell.

Where is the fuel pump reset switch location on the Chevy Silverado?

The Chevrolet Silverado truck has a fuel pump reset switch that can be found on the toe board of the vehicle. This is somewhat easy to locate.

Where is the fuel pump reset switch located?

The fuel pump shut-off switch is located behind an access panel on the right side of the luggage compartment. The fuel pump shut-off switch has a red reset button on top of it.

How do you reset a fuel pump relay?

How to Reset a Fuel Pump Shut Off Switch
Locate your car’s inertial trigger or airbag control module. Push the button on the inertial switch; it should be clearly marked as the fuel pump reset, and may be in a contrasting color to the case.

What is the fuel reset button for?

In the event of an accident, the “Fuel Reset Button” will turn off the fuel pump and system.

How do you reset the fuel pump sensor?

Press and hold the “Trip/Odo” button. Turn the ignition switch on and hold the “Trip/Odo” switch for about two seconds. Then, release the “Trip/Odo” button, press it again (do this three or four times), and finally hold it for about four to five seconds until the leveling information shows on the Odometer.

What would cause a fuel pump to not turn on?

If the fuel pump is not coming on, and the fuse and relay are good, then it may be possible that there is a problem with the pump or the fuel pump circuit. If it is not then there may be some sort of wiring issue before the fuel pump relay, perhaps a wiring issue or other problem with the ignition switch.

Where is fuel pump relay located?

Most fuel-pump relay units are located under the dashboard near the steering column. In some cases, the unit is located in the area where the steering column is mounted or near the engine’s firewall.

How do I reset my inertia switch?

Press down the rubber reset button on the top of the inertia switch. 3. Turn the ignition switch to position ‘II’, pause for a few seconds, then return the key to position ‘0’.

How do you know if an inertia switch is tripped?

if it tripped,then the button will pop up and all you need to do is push it back down until it clicks/stays down. it’s rare for the inertia switch to fail,but possible.

How do you know if an inertia switch is bad?

Symptoms of a Bad or Failing Fuel Pump Shut Off Switch
Engine suddenly stops while driving.Switch that trips for no reason.No start condition.

What does the fuel pump control module do?

The Fuel Pump Driver Module controls the voltage delivered to a vehicle’s fuel pump. By controlling the voltage, the module maintains optimal fuel pressure and fuel delivery to the engine throughout its full operating range.

How much is a fuel pump for a 2003 Chevy Silverado?

The average national cost for a fuel pump replacement across all vehicles is roughly between $611 and $894.

How much does it cost to replace a fuel pump in a Chevy Silverado?

Chevrolet Silverado 1500 Fuel Pump Replacement Cost Estimate. Labor costs are estimated between $193 and $243 while parts are priced between $878 and $1,048.